Des jonquilles en papier crépon

Imprimez le gabarit disponible sous forme de fichier PDF pour cette idée. Découpez toutes les parties de la jonquille. N'oubliez pas de couper selon le sens d'étirement indiqué sur chaque gabarit. Coupez deux feuilles et une bande de papier crépon vert de 1 x 25 cm pour recouvrir le fil de fleuriste.

Start by cutting off one end of five stamens. Attach the five stamens onto one end of a floral stem wire.

Use the glue gun for gluing the centre of the daffodil. Glue one side of the crepe paper square against the opposite side, forming a tube.

Squeeze one end of the tube around one end of the floral stem wire, ensuring that the stamens are inside the tube. Make sure that the crepe paper is gathered around the floral stem wire.

Shape the tube into a bell-shaped flower middle. Stretch the crepe paper at the bottom with a forefinger inside the tube and a thumb on the outside of the tube. Lightly bend the top edge of the tube all the way around whilst stretching the crepe paper as you go along, making wrinkles.

Round each petal with a bone folder by pulling the petal between the bone folder and your thumb; the same technique as curling a ribbon with scissors.

Shape the petal by stretching the middle of it, so that it becomes round. Repeat this procedure with all the petals.

Attach the first petal onto the floral stem wire with a blob of glue from the glue gun. Attach another three petals in a staggered fashion.

Attach another three petals between the first three petals.

Stretch out the long thin piece of green crepe paper.

Fasten one end of the crepe paper onto the bottom part of the petals on the daffodil, hiding the bottom part of the petals.

Cover the floral stem wire by wrapping the crepe paper at an angle around the floral stem wire, securing with Multi Glue as you go along.

Attach the daffodil's green leaves onto the floral stem wire using a glue gun. Place the two leaves approx. 5 and 10 cm from the other end of the floral stem wire. Continue covering the floral stem wire, hiding the ends of the leaves. Finish the covering of the floral stem wire once you have reached the end. Tear off the excess crepe paper strip. Secure with a blob of glue.

Add details onto the daffodil with watercolour markers to give it a bit of life. Paint onto the edge of the daffodil petals as shown in the photo. .

Spread the colour by using a wet brush.

Make a small spring bouquet by putting the daffodils together with crepe paper tulips.

Print the template here.