Fleurs en papier crépon Cosmos

1   Imprimez et découpez le gabarit disponible sous forme de fichier PDF en bas de page. Découpez toutes les parties de la fleur. N'oubliez pas de suivre la direction d'étirement du papier crépom indiquée sur le gabarit. Découpez des feuilles pour la tige, un morceau de papier crépon vert pour les feuilles recouvrant le bas des pétales, un morceau de papier crépon jaune pour les étamines et un morceau de papier crépon vert de 1 x 20 cm pour recouvrir le fil de fleuriste. Vous pouvez utiliser du ruban floral à la place.

2   Cut notches in the yellow piece of crepe paper for the stamen. Attach onto one end of the floral stem wire using a glue gun.

3   Round each petal with a bone folder by pulling the petal between the bone folder and your thumb; the same technique as curling a ribbon with scissors.

4   Shape the petal by stretching the middle of it, so that it becomes round. Repeat this procedure with all the petals. Twist the edge of the petal back and forth along the entire edge in order to create a wavy edge. Repeat this procedure with all the petals.

5   Twist the other end of the petals to make them narrow and pointed.

6   Attach the petals onto the lower part of the stamen. Attach four petals staggered around the stamen.

7   Now attach another four petals between the first four petals.

8   Now attach the green piece of crepe paper for the leaves covering the stamen and the bottom of the petals, securing it around the floral stem wire.

9   Stretch out the long thin piece of green crepe paper for covering the floral stem wire. Fasten one end onto the bottom part of the leaves. Cover the floral stem wire by wrapping the crepe paper at an angle around the floral stem wire, securing with Multi Glue as you go along.

Template   Print the template here.