Cards with Christmas Boots
#v11883
New simple cards with cut-out boot designs and bows with a 3D effect.
#v11883
Comment faire Téléchargez nos instructions étape par étape
1 Draw the boot using the template and cut it out from Vivi Gade design paper. Cut out the heel and the toe in a different colour design paper.
2 Cut the back ground from fibre paper – cut it slightly smaller than the actual card.
Use pinking shears for cutting the fibre paper; it looks great.
TIP: Place a piece of paper behind the fibre paper before cutting; then it's much easier to use the pinking shears.
3 Attach the fibre paper and the boot with double-sided adhesive tape and 3D foam pads.
4 Make a bow from a strip corresponding to the entire length of the paper (approx. 30cm) and approx. 1cm wide.
5 Attach a small piece of the strip around the bow to keep it together.
Glue with a small blob of glue on the back.
6 Attach the bow to the boot with 3D foam pads.
TIPS: if the design is attached upright, you may hang the card on a piece of string.
Allez aussi explorer dans
